Collected Expansion Modules

EVE ELECTRONICS

  • VD-MB 80 COLUMN VIDEO/EXPANSION
  1. -Usable with 80 Character Monochrome Composite Monitor & SOME High Resolution composite Color Monitors
    -Four (4) Expansion slots for standard EVE products (SP-1, SP-1 P, SS-CC)
    -Optional Power Supply to replace ADAM printer power supply"
    -Composite Video Output - Software selectable so you can choose between ADAM's normal video or the 80-Column video under CP/M.
    -Full emulation of the Heath H19/H89 video display terminal
    -Optional VT·1 00 EmulatiOn/Programmable display parameters
    -8D-Column display of MOST CP/M Software (WordStar, DBase2, SuperCalc, etc.)
    -24 Line x 8D-Col Display w/25th status line
    -Upper & Lower Case with descenders
    -Nonn & Inv video display + Line/Block Graphics
    -ADAM Printer Jack
  2. Original Reciept
 
MICRO INNOVATIONS
  1. POWERMATE EXPANDABLE HD/FLOPPY
  2. -The basic Powermcte product consists of the Powermate interface board, a 2 or 4 drive external disk drive enclosure, all necessary interface cables, and all software needed to operate the Powermate with the ADAM. The interface board (which mounts in ADAM expansion slot #2) contains two RS-232 serial ports, a Centronics compatible printer port, the expansion memory board port, and the external disk enclosure interface port, The Powermate 2 external enclosure contains the disk subsystem power supply, the disk controller board, a hard disk drive, and space for mounting a second disk drive (either a second hard disk drive or a floppy disk drive), The Powermate 4 external enclosure includes all the standard features of the Powermate 2 but has provisions for adding a second hard disk drive and up to 2 floppy disk drives,

 

 
ORPHANWARE
 
EVE ELECTRONICS
  • SP-1
  • -Opens the ADAM to the outside world. The SP-1 includes an RS-232C Serial channel, and a (Centronics) Parallel printer channel. The SP-1 allows the use of hundreds of different printers, both high speed dot matrix, and letter quality. With the SP-1 you can now use standard models, and direct connect to other computer systems. The SP-1 comes with software for use with SmartBasic, and CP/M. The SmartBasic programs allow the selective output to either the serial port, the parallel port, or the ADAM printer. A program is also provided to allow 'draft' printout of a Smartwriter file to either the serial or parallel port. The CP/M program allow the 'IOBYTE' in CP/M to be set for the desired output.
  • SS-CC
  • -Now you can give ADAM a 'VOICE'. The EVE speech unit may be used with your programs to add capabilities to your ADAM that are only limited by your imagination! Also on this interface unit is a 'real time' clock calendar circuit so you, and ADAM will now have a access to the time and date as needed. Software included with the SS-CC: a standard phoneme library, and sample 'Talk' & 'Clock' programs. For use with both SmartBasic and CP/M.

 

 
OPCODE
  • SUPER GAME MODULE (SGM)
  • -

 

 

8bit Milli
 

 

RAMBOard

  • The RAMBOard will allow you to have 32k of RAM on your ColecoVision instead of the standard 1k. This extra RAM will allow you to play many of the upcoming 8 Bit Milli games as well as allow you to play any game that requires a Super Game Module but will run on a Coleco Adam without the Super Game Module. Many games that require a Super Game Module only require the 32k of RAM that it contains and does not check for the presense of the AY sound chip. The rule of thumb is, if the game will play on a Coleco Adam without a Super Game Module attached you can use the RAMBOard to play the same games on the ColecoVision. The RAMBOard does NOT contain a sound chip so you will not be able to hear the sound from these games unless they use the built in ColecoVision sound chip but you can play them. A partial list of Super Module Games you can play using the RAMBOard on a ColecoVision are shown below. Note, though the RAMBOard will allow you to play these games, but you will still need to have an actual copy of the game on cartridge.
 
HI-TEK RESEARCH
 
  • RS-232 SYSTEM EXPANSION
  • RS-232 OPTION. As of now the COLECO ADAM'S POWER can be fully appreciated. with the RS-232 you may now operate a wide range of other GENERIC ACCESSORIES such as a DOT MATRIX PRINTER oR maybe a MODEM or even an EPROM PROGRAMMER. The possibilities ore now virtually endless. With a little time in vestment to develop some software this and much more will run with your ADAM .
  • Hi-TeK Reserch RS-232 System Expansion

 

 
COLECO
 
  • AUTODIALER
  • - Tone dialer for the side expansion port
 
TRYSID

 

 
BONAFIDE SYSTEMS
 

MIDI-MITE

MIDI-MITE (as it's been named) interface owners are already aware, the unit comes complete with everything you or I need to get started. The package comes with the interface, two MIDI cables, one 60 conductor ribbon cable to connect it to ADAM, two software programs on digital data pack, and three instruction manuals. All you need to do is to plug the ribbon cable into the side port of your ADAM CPU, then into the side of the MIDI-MITE. Looking at the interface, there are four jacks on the right side for connecting external MIDI devices.

MIDI-Miti Instructions

Registration Card

Mini Recorder

VT_Player

YouTube Video

 
LUNDY ELECTRONICS
 

USB/MOUSE JOYSTICK
  • Coleco USB mouse/joystick adapter with ribbon splitter cable and Mini-B USB cable for power and software updates. Includes support for third party NES and SNES USB joypads.
 
LUNDY ELECTRONICS
 
COLECO ADAM PRINTER TO ADAMNET ADAPTER
  • This ADAMnet to Coleco printer adapter with reset silence switch is used to test or use a factory printer while using a modified console with an internal or external power supply.
 
ORPHANWARE
 
EXTERNAL EXPANSION SERIAL PORT
  • T
 
ColecoM Say GM
 
COLECOM SAY GAME MODULE
  • T

++